CALL US: 408-848-2001, MON-FRI 8AM-5PM PST
0 item(s)
Pelco EC-1504C-W Ethernet Connect Local or Remote Four Port Extender
Pelco EC-1504C-W Ethernet Connect Local or Remote Four Port Extender

Pelco EC-1504C-W Ethernet Connect Local or Remote Four Port Extender

Your Price:$600.00
In Stock.

Designed to be a cost-effective, general-use product, Provides maximum flexibility in this applications without any programming. The Ethernet Connect is used to extend Ethernet over copper (EoC). It extends up to 16 ports of 10/100 Mbps Ethernet with pass-through PoE over coaxial cable. Extends up to 16 ports of 10/100 Mbps Ethernet. Single-channel units can be powered from a PoE source, allowing for an installed network where power is not readily available. Units provide the ultimate flexibility for extending a powered device (PD) over long distance copper. DIP switches are provided for the user to select local or remote settings. All application configurations should be verified at the time of ordering to facilitate ease of installation.

Features

  • Extends Ethernet up to 1,524 m (5,000 ft) at 10 Mbps or 549 m (1,800 ft) at 100 Mbps over Coaxial Cable
  • Extended Temperature Operation from –40° to 75°C (–40° to 167°F)
  • Extended Pass-Through PoE Meets the IEEE802.3af Standard for Power over Ethernet
  • Full 10/100 Mbps Bandwidth
  • Supports Multicast, Unicast, and Jumbo Frame
  • Symmetric Bandwidth Provides Consistent Upload and Download with Virtually Zero Packet Loss over the Total Usable Distance
  • Type Tested to RFC-2544 TCP/IP Network Bandwidth Packet Transmission Standards
  • User-Selectable Data Rate for Maximum Bandwidth and Transmission Distance Utilization
  • Complies with all Major IEEE Standards and RFC Network Protocols for UDP, TCP/IP, and HTTP/HTTPs
  • Tested and Certified by an Independent Laboratory for Full Compliance with the Environmental Requirements (Ambient Operating Temperature, Mechanical Shock, Vibration, Humidity with Condensation, High-Line/Low-Line Voltage Conditions, and Transient Voltage Protection) of NEMA TS-1/TS-2 and the Caltrans Specification for Traffic Signal Control Equipment
  • LED Status Indicators Confirm Operating Status
  • Designed and Manufactured in the USA
THIS PRODUCT IS USED AND IN GOOD CONDITION.

Related Items